Heavy Duty for 2" ID Silicone Hoses

Heavy Duty for 2" ID Silicone HosesThis heavy duty spring loaded T bolt clamp is used on 2" ID (5 ply) silicone hoses. It is recommended in any air to air application or any application using silicone hoses, especially if you have had trouble with the hose coming off. Spring loaded T bolt clamps assure a firm hold, regardless of the expansion and contraction caused by changes in temperature and pressure. Stainless band and bridge, plated spring and washers, anodized bolt and nut.

especially if you have had trouble with the hose coming off

91" center-to-center

You install it in the end of the 3" rubber elbow or hump hose

Type AN Swivel Braided PTFE Reusable Hose End AN Size (Female) AN08

Recommended clamps are 94100-0325 on the small end and 94100-0338 on the big end

RS20X175X25

Every component

This rubber reducing 45-degree intake elbow can be used any place where you are connecting a 6" OD tube and a 5-1/2" OD tube

our kit provides a straightforward installation that can be completed in approximately 30 – 45 minutes using only common hand tools - no specialized equipment or engineering degree required

180 degree Rubber Reducing Elbow

-6 Angle Straight Hose Compatibility Braided Rubber Hose (NOT PTFE Lined) Fluid Compatibility Petrol

This reducing hump hose connects 3" OD and 2-3/4" OD intake tubes together