7" OD X 12" Long

7" OD X 12" LongStandard aluminum intake tubing. 6061T6 alloy . 125 wall thickness. Cuts easily with a hack saw. About 1 1 2 inches on each end goes inside an intake hose (minimum 1 inch). Mill finish (as it arrives at our location from the mill after traveling on a truck and being handled several times) may have minor defects and small scratches, but no dents or major defects. Made in USA.

If the small end is mounted to the standard 2-5/16" carb or tube

This 22 degree silicone elbow is 3-1/2"

90HL70R5590L70R55

Special tight-weave aramid reinforcement handles more pressure and lasts longer than most other brands

5" OD and 4" OD intake tubes

and then the 5-1/2" intake tube fits into the insert

This spring-loaded T-bolt clamp is used on 3

This 5 inch hump hose is used to connect two 5" OD intake tubes

This hose hose handles 500 degrees F

This reducing 90-degree intake elbow can be used where you are connecting a 3" OD tube and a 2-1/2" OD tube

creating more volume internally without increasing height

This 2-1/2" ID silicone coupler is 3 inches long