3" ID X 3" Long

3" ID X 3" LongThis straight coupler is useful when you don't have clearance for the "hump" of a standard hump hose. It's only disadvantage is the fact that it doesn't have the few degrees of flex that a hump hose has. Temp rated at 250 275F. Made in USA. Recommended clamps are 94100 0338. S300X300

Recommended clamps are 94100-0400 on the big end and 94100-0350 on the small end

This reducing hump hose connects 6" OD and 5" OD intake tubes

Recommended clamps are 94100-0400 on the small end and 94100-0550 on the big end

This reducing 45-degree intake elbow can be used any place where you are connecting a 7" OD tube and a 6" OD tube

This 90 degree silicone elbow is 2" ID

Includes pre-cut tubing and the grommet strip for the 4-1/4" hole

Recommended clamps are 94100-0550 on the small end and 94100-0650 on the big end

This standard 10 inch hump hose is used to connect two 10" OD intake tubes

About 1 to 1-1/4 inches on each end goes inside an intake hose (minimum 1 inch)

Fits most Ford throttle bodies and MAF's and adapts to standard 3" tubing

90HL70R5090L70R50

For version without anti-rattle nub